|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 5th 08, 05:22 PM
posted to alt.comp.periphs.mainboard.gigabyte
|
|||
|
|||
GA-965P-DS3 F13Q BIOS Issue
When I got my E8400 back in January, I updated my GA-965P-DS3 rev 3.3 board
to the F13o BIOS which provided support for the 45nm processors. A few months later, Gigabyte released the F13Q BIOS, which also claimed to support the 45nm processors but gave no other details on changes. After flashing F13Q, I noticed that my CPU fan (Arctic Freezer 7 Pro) was much noisier than before although the CPU temps (per CoreTemp) were about the same. I did not have EIST or C1E enabled on either BIOS. EasyTune showed that the CPU fan was running at about 2450 RPM, near the top of its range. I flashed back to F13o and the CPU fan speed dropped back to 1700 RPM and all was quiet again. The CPU temp stayed the same. Has anyone else experienced a similar problem w/F13Q? Does anyone know what other changes might have been made in F13Q? John 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GA-965P-DS3 F12 BIOS | John Bissell | Gigabyte Motherboards | 0 | June 24th 07 11:53 PM |
| Gigabyte GA-965P-DS4, ACPI and BIOS | [email protected] | Homebuilt PC's | 1 | March 25th 07 02:02 PM |
| GA-965P-S3 BIOS F5 | Jack Spencer | Gigabyte Motherboards | 1 | October 8th 06 10:29 PM |
| feed back for Bios of the 965P-DQ6 | LOGITEX | Gigabyte Motherboards | 0 | August 27th 06 03:51 AM |
| GA-965P-DQ6 beata bios | Richard Dower | Gigabyte Motherboards | 0 | July 27th 06 06:42 AM |
Linear Mode
