RAID Help GA-K8NF-9

I am in the process of putting my new computer together and am trying
to install Windows XP 64bit edition. I am running into problems when
trying to set up Raid Striping in my 2 SATA HD's. I enter the RAID
setup utility and it appears as though my drives are seen and the array
is set up fine, however, when I go to install windows and choose F6 to
install the v.4.34a drivers, they appear to load, but when windows goes
to install it shows 2 drives and wants me to format them. Is this
correct?

Nevermind, I resolved the issue myself.

What was the solution? It might help others (or myself when I go to do the
same thing next week)
wrote in message
oups.com...
Nevermind, I resolved the issue myself.

On Sat, 11 Jun 2005 21:44:56 GMT, Cypher wrote:

What was the solution? It might help others (or myself when I go to do the
same thing next week)
wrote in message
oups.com...
Nevermind, I resolved the issue myself.


I didn't load any driver when was installing win x64 and it didn't ask me
none, it works all fine !

He's talking about a Raid setup though, not a single hard drive, and for
Raid, you need drivers.


"Nikonja" wrote in message
...
On Sat, 11 Jun 2005 21:44:56 GMT, Cypher wrote:

What was the solution? It might help others (or myself when I go to do
the
same thing next week)
wrote in message
oups.com...
Nevermind, I resolved the issue myself.


I didn't load any driver when was installing win x64 and it didn't ask me
none, it works all fine !