If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power supply failure
Hello group,
I hope this is the right place to ask this. I need some info from others. Anyone had a new (30 day's or so) power supply fail during use and the supplier will only replace the supply not the drives that don't work now? They say they aren't responsible for the damage to contact the manufacturer. ME |
#2
|
|||
|
|||
"ME" wrote in message ... Hello group, I hope this is the right place to ask this. I need some info from others. Anyone had a new (30 day's or so) power supply fail during use and the supplier will only replace the supply not the drives that don't work now? They say they aren't responsible for the damage to contact the manufacturer. ME That makes perfect sense. If the power supply failed, that is the manufacturer's problem. If the supplier is nice enough to replace the power supply for you, you should be glad that they will do that much, at least. But it might be better to buy a new power supply WITHOUT sending your current power supply back to the supplier. If your power supply damaged your hard drives, whoever manufactured the power supply should be responsible for replacing your hard drives. I don't know if the hard drive manufacturer will do that or not, but they definitely won't do it before being offered proof that the power supply is defective. If you've already sent the defective power supply back to the supplier, what kind of proof can you offer to the manufacturer that their power supply is defective? -Dave |
#3
|
|||
|
|||
"Dave C." wrote in message ... "ME" wrote in message ... Hello group, I hope this is the right place to ask this. I need some info from others. Anyone had a new (30 day's or so) power supply fail during use and the supplier will only replace the supply not the drives that don't work now? They say they aren't responsible for the damage to contact the manufacturer. ME That makes perfect sense. If the power supply failed, that is the manufacturer's problem. If the supplier is nice enough to replace the power supply for you, you should be glad that they will do that much, at least. Replacing the power supply is a simple matter of warrenty. My issue is the hdd/dvd player (they were on the same power line) and video card that does not work or is have problems now that were not there before the failure. Example, Friday night I watched Xmen 2 with the dvd player. Tuesday I hooked it back to the PIII system (it has worked on for about 5 years) and it locks up during playback and has read error's in diagnostic's. The 40 GB hdd, has 8GB of bad crc files on it and SMART drive say's it's "imenant failure" on bootup. It was a backup drive on the system that had the power supply failure. The Vidoe card, works but in XP Pro device manager it say's it cant get info from the "cds" about the display card. It wont run Far Cry now keeps failing with a message that the program has stopped becasue it's not getting a signal from the vidoe card. When I first was able to get the P4 back up Thursday afternoon I had to re do the bios (thanks to Asus for the crash free bios) as it was currupted. I'm not looking for a new system here. Just about $200.00 in parts replaced that worked before the failure but dont now. I'm not asking for top of the line stuff or for anything for my time or effort's such as testing and the like. But it might be better to buy a new power supply WITHOUT sending your current power supply back to the supplier. The supplier did not ask for and after three emails refering to it's return, now wont get the power supply back. I've saved it and will see about having it checked out. If your power supply damaged your hard drives, whoever manufactured the power supply should be responsible for replacing your hard drives. The manufaturer or the supplier of the supply? I don't know if the hard drive manufacturer will do that or not, but they definitely won't do it before being offered proof that the power supply is defective. Maxtor and WD say the failure was an external so they wont replace anything. Asus said the same but I was able to get the board working and it has passed all diagnostic's I've thrown at it for the past week so I'm hoping I'm ok with it.Also the memory and CPU have tested ok. I dont know why the video is messing up so much. Unless it's more sensative to the 3.3/1.5 line and they surged on the failure.. If you've already sent the defective power supply back to the supplier, what kind of proof can you offer to the manufacturer that their power supply is defective? -Dave Well, it sit's next to my desk in it's original box with it's receipt waiting for the next step. ME |
#4
|
|||
|
|||
Replacing the power supply is a simple matter of warrenty. My issue is the
hdd/dvd player (they were on the same power line) and video card that does not work or is have problems now that were not there before the failure. Example, Friday night I watched Xmen 2 with the dvd player. Tuesday I hooked it back to the PIII system (it has worked on for about 5 years) and it locks up during playback and has read error's in diagnostic's. The 40 GB hdd, has 8GB of bad crc files on it and SMART drive say's it's "imenant failure" on bootup. Yes, I understand exactly what you are saying. Let's say the defective power supply is enermax brand. (not that it is, but let's say it is) In the same way, let's say your hard drive is maxtor brand your video card is evga brand. You bought all of this stuff from a retail store called XYZ Bytes in anywhere, USA. Your power supply dies, taking your hard drive and video card with it. Enermax should be responsible for replacing your maxtor hard drive and your evga video card. IF XYZ Bytes says they will exhange your defective Enermax power supply for you, great. But before you do that, you need to contact Enermax about the maxtor hard drive and evga video card that were damaged. If you can convince Enermax to replace those components for you, Enermax will probably want you to send your defective Enermax power supply to Enermax first. You have no beef with XYZ. In fact, you should not pursue this matter through XYZ at all, as you will likely screw yourself if you do. As a last resort, take XYZ up on their offer to exchange the power supply for you. But first try to get Enermax to replace all the bad components, as this is Enermax's problem. That is, assuming your power supply was Enermax brand. -Dave |
#5
|
|||
|
|||
Having worked with attorney's many times over the years I disagree with this
"tough luck". I was very careful to check both the original invoice, package contents and the company's website for any such statement and there isn't one. I've also printed off all and will save them. They have said they have a warrenty on the product to address but feel it stop's at the power supply only. The issue here is, as I understand it so far, there is no other responcable party to address this to. Maybe I can find some similar case's. "ric" wrote in message ... "Dave C." wrote: You have no beef with XYZ. In fact, you should not pursue this matter through XYZ at all, as you will likely screw yourself if you do. As a last resort, take XYZ up on their offer to exchange the power supply for you. But first try to get Enermax to replace all the bad components, as this is Enermax's problem. That is, assuming your power supply was Enermax brand. Even the best PSUs usually have the following, or similar, paragraph in their warranty: THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. IN NO EVENT SHALL [xxx] BE LIABLE FOR DAMAGES FOR A BREACH OF WARRANTY IN AN AMOUNT EXCEEDING THE PURCHASE PRICE OF THIS PRODUCT. In other words, tough luck. |
#6
|
|||
|
|||
ME wrote:
I hope this is the right place to ask this. I need some info from others. Anyone had a new (30 day's or so) power supply fail during use and the supplier will only replace the supply not the drives that don't work now? They say they aren't responsible for the damage to contact the manufacturer. The supplier is absolutely correct. Even the manufacturer's liability is questionable. |
#7
|
|||
|
|||
"Dave C." wrote:
You have no beef with XYZ. In fact, you should not pursue this matter through XYZ at all, as you will likely screw yourself if you do. As a last resort, take XYZ up on their offer to exchange the power supply for you. But first try to get Enermax to replace all the bad components, as this is Enermax's problem. That is, assuming your power supply was Enermax brand. Even the best PSUs usually have the following, or similar, paragraph in their warranty: THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. IN NO EVENT SHALL [xxx] BE LIABLE FOR DAMAGES FOR A BREACH OF WARRANTY IN AN AMOUNT EXCEEDING THE PURCHASE PRICE OF THIS PRODUCT. In other words, tough luck. |
#8
|
|||
|
|||
"Dave C." wrote in message ... Snip Yes, I understand exactly what you are saying. Let's say the defective power supply is enermax brand. (not that it is, but let's say it is) In the same way, let's say your hard drive is maxtor brand your video card is evga brand. You bought all of this stuff from a retail store called XYZ Bytes in anywhere, USA. Your power supply dies, taking your hard drive and video card with it. Enermax should be responsible for replacing your maxtor hard drive and your evga video card. YEs, I concure in this case I would say that either "enermax" (Actually it's AG) or XYZ Bytes (NWCA.com) is responcable. All my dealing's were with XYZ not enermax so I'm inclined to them. I did find this image. This is not the company but this is the power supply I got. http://us-depot.com/frshag520wad.html IF XYZ Bytes says they will exhange your defective Enermax power supply for you, great. But before you do that, you need to contact Enermax about the maxtor hard drive and evga video card that were damaged. If you can convince Enermax to replace those components for you, Enermax will probably want you to send your defective Enermax power supply to Enermax first. You have no beef with XYZ. In fact, you should not pursue this matter through XYZ at all, as you will likely screw yourself if you do. As a last resort, take XYZ up on their offer to exchange the power supply for you. But first try to get Enermax to replace all the bad components, as this is Enermax's problem. That is, assuming your power supply was Enermax brand. -Dave Some good news, just doing some searching online and it turns out that there's a Warranty act law that say's if they "claim" anything as conditional under the warranty they have to claim it. Also it has to be included in the written that they will only replace the part they have to say so in the warranty. It's not as "ric" has said in his post. as they warranty on the website doesn't say this, under the same law they do have liability. I have to read some more and print off some of this. ME |
#9
|
|||
|
|||
w_tom" wrote in message
... Overvoltage protection was defacto standard on power supplies even 30 years ago. Where did overvoltage protection come in this? The supply died. It is a requirement in Intel specifications. But importers have discovered a lucrative market - computer assemblers who don't even know what a power supply must do nor read those specs. Was that power supply $40 retail? NO, as the link shows they run only $19.95 plus S&H. To sell at that price, it must 'forget' to install many essential functions. Also forgets to provide any specifications - any claim that it will provide essential functions. Yes, there arent much as far as spec's on the box, I did notice that right away. Damaged computer parts simply because purchase was made without first verifying supply performed these and other essential functions: Specification compliance: ATX 2.03 & ATX12V v1.1 Acoustics noise 25.8dBA typical at 70w, 30cm Short circuit protection on all outputs Over voltage protection Over power protection 100% hi-pot test 100% burn in, high temperature cycled on/off PFC harmonics compliance: EN61000-3-2 + A1 + A2 EMI/RFI compliance: CE, CISPR22 & FCC part 15 class B Safety compliance: VDE, TUV, D, N, S, Fi, UL, C-UL & CB Hold up time, full load: 16ms. typical Efficiency; 100-120VAC and full range: 65% Dielectric withstand, input to frame/ground: 1800VAC, 1sec. Dielectric withstand, input to output: 1800VAC, 1sec. Ripple/noise: 1% MTBF, full load @ 25°C amb.: 100k hrs Where is the requirement that these must be tested before use? In the legal system, you may have a case with a good lawyer. But if I was on your jury, I would have to vote against you. Not much of a jurer if you are ready to "vote" without hearing the case or seeing hardly any of the evidence. Your power supply probably did exactly as it claimed. It did what power supplies even 30 years ago did not do. But this is what happens when a computer assembler does not first learn basic technology or read manufacturer specifications. Did he buy your supply on bean counter principles - or did he built the system using engineering principles? Where are the manufacturers long list of specifications? None of the above, I got it online based on my needs. |
#10
|
|||
|
|||
I didn't pay $16.00. Warranty is the same issue.
"Dave C." wrote in message ... YEs, I concure in this case I would say that either "enermax" (Actually it's AG) or XYZ Bytes (NWCA.com) is responcable. All my dealing's were with XYZ not enermax so I'm inclined to them. I did find this image. This is not the company but this is the power supply I got. http://us-depot.com/frshag520wad.html $16 for a 520W power supply? Yikes. That's like $100 for a 20 carat diamond. -Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
help, please, with Compaq Presario power supply problem | Jacques Clouseau | General | 6 | June 9th 04 06:44 PM |
Won't Power Up after Power Outage | Greg Lovern | Homebuilt PC's | 7 | February 8th 04 01:47 PM |
How can I make motherboard to restart after power loss automatically? | Amiran | General | 1 | September 24th 03 11:35 PM |
ATX Power Supply Failure? | Peter Hemmings | Homebuilt PC's | 6 | July 19th 03 11:28 PM |