52.16 (tv-out) overlay clone mode not working

Hi all, in my GF4 4200Ti when I select (in nview) "clone" display mode, and
then set "full screen overlay video device" to my secondary screen (TV) I
get a flickering white image. Even the refresh rate is the default (60Hz),
it should be this for TV, and my previous driver 45.23 do it 100% ok. I
tried dozens of alternative configs but with no success.
And more irritating is when I do not select any fullscreen device for
overlay... the card can't do overlay in the desktop.
I remember that this happened many times in other "beta" drivers 4x.xx, but
never in final releases.

Any "repro" over there?.

Greets, [s]arrow.

"[s]arrow" wrote in message ...
Hi all, in my GF4 4200Ti when I select (in nview) "clone" display mode, and
then set "full screen overlay video device" to my secondary screen (TV) I
get a flickering white image. Even the refresh rate is the default (60Hz),
it should be this for TV, and my previous driver 45.23 do it 100% ok. I
tried dozens of alternative configs but with no success.
And more irritating is when I do not select any fullscreen device for
overlay... the card can't do overlay in the desktop.
I remember that this happened many times in other "beta" drivers 4x.xx, but
never in final releases.

Any "repro" over there?.

Greets, [s]arrow.

I have exactly the same problem. If, however, you use an analogue
monitor and a digital monitor (with either as the primary), overlays
work fine on the primary or secondary device. Changing the TV between
primary and secondary doesn't change anything, but if you try to put
the other device (the monitor) as the fullscreen device, that works
fine...
I think I'm going to have to go back to 45.23, for the time being...

STeve