If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
monitor OUT OF RANGE
ibm g54 monitor. windows nt. i think the res was set too high. boot up in
vga mode, change to lower res, boot up normal and still doesn't work. only res options in vga are 640x480 and 800x600. refresh freq can only be set to 'use hardware default settings.' when vga mode first boots up, i get a message stating that i need to update my graphics display driver. that's not true since i haven't touched my drivers. any help appreciated. thanks. |
#2
|
|||
|
|||
it`s not picking up a display driver....
re-install it and set a lower refresh rate brett..... "M77" wrote in message ... ibm g54 monitor. windows nt. i think the res was set too high. boot up in vga mode, change to lower res, boot up normal and still doesn't work. only res options in vga are 640x480 and 800x600. refresh freq can only be set to 'use hardware default settings.' when vga mode first boots up, i get a message stating that i need to update my graphics display driver. that's not true since i haven't touched my drivers. any help appreciated. thanks. |
Thread Tools | |
Display Modes | |
|
|