A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » System Manufacturers & Vendors » Compaq Computers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Compaq FAQ



 
 
Thread Tools Display Modes
  #1  
Old August 7th 03, 04:22 PM
HH
external usenet poster
 
Posts: n/a
Default Compaq FAQ

Helpful Links:



For drivers, software, manuals/docs

http://h18007.www1.hp.com/support/files/

For Compaq spare parts

http://sparesstore.compaq.com/sparesstore/default.asp?

For the Presario Customer Communities (Forums)

http://communities.compaq.com/servle...=121&RPAGEID=0





Q) How do I enter the BIOS on my Presario?

A) Normally, hitting F10 at the Compaq logo (cursor to upper right corner)

at bootup. If this does not work, it means you have an earlier model, 1996

or earlier, that retains Setup info on a small non-DOS partition at the

front of the hard drive, not in ROM, and this partition is damaged or

missing. Most Commercial desktops/notebooks (DeskPros, Prolineas,

Armadas/Elites, etc.) also have this partition. If this is the case, go

he



http://h18007.www1.hp.com/support/files/



Select your model desktop or notebook and download the Softpaq for Computer

Setup. Run this SoftPaq and it will create a boot floppy from which you can

enter the BIOS. You might want to download the Personal Computer Diagnostics

SoftPaq as well.



Q) Can I disable the onboard video/audio on my Presario and install

different ones.

A) Yes. As for video, installing the new card normally will disable the

onboard video. Sometimes, you may have to reset your video to Standard VGA

in Device Manager in Windows first, then shut down and install the PCI video

card. On Presarios with an AGP slot, this is not necessary.

The onboard audio is disabled in Windows device manager, then shut down and

install the PCI audio card, reboot and install the drivers.



Q) How do I get QuickRestore Discs for my Presario?

A) In the U.S., call 800-841-2761. Have your model number or serial number

(it's usually on a white barcode sticker on the back or side of the PC).The

cost is $10 for the discs.

Outside the U.S., contact Compaq support in your region for more info.



Note: Since Microsoft no longer supports operating systems earlier than
Millenium, Compaq may not


have QR CDs left for those models that came with Win 95, 98, or 98SE.





Q) How can I reinstall my audio (or video, modem, etc.) driver or specific
software without doing a full


restore?

A) Most newer model Presarios have a Selective Restore Option. Double click

on the Compaq Support desktop icon, or select it from the menu. Select

QuickRestore, then Selective Restore. you can then select which driver(s) or
software you wish to


reinstall.

NOTE: If you have upgraded the operating system or if the Compressed Compaq

folders (CPQDRV, etc.) on the System Save partition have been deleted, or if

the Presario model is an older one without Selective Restore, the above may
not apply. In this case,


check the website link above to see if the driver

is there for your model and OS. For software, go into the icons directory on
the QuickRestore CD and


and open each image. Once you find the image for the software you wish to
reinstall, then the file name


is the directory name of the software install directory.



That said, some of the programs are not separately installable.





Q) I've installed a new hard disk (or CD-ROM/DVD drive) in my

Presario/DeskPro etc., and it is not recognized. Why?

A) Compaqs come with Cable Select IDE cables. Any drive attached to them

must be jumpered CS for Cable Select. You will also have to partition (using

FDISK) and format the drive before it will be recognized.



Q) I've installed a new 80 GB hard drive in my older Presario, but only 8

GB is recognized. Where is the other 72GB?

A) Unfortunately, many older Presarios ( Pre-1996) have an 8GB hard drive

size limit in BIOS. There are no BIOS upgrades from Compaq to raise this

limit, however, there are two ways to overcome the limit:

1. The best way is to install a PCI IDE controller card with its own BIOS.

These cards are not expensive, less than $50, and also allow full ATA100/133

transfers as well. Promise and SIIG both offer these cards.

2. the other way is to install BIOS overlay software, available from the

hard drive manufacturer's website. This method will slow down drive

operation however.



Q) Can I put a different motherboard in my Presario/DeskPro?

A) Yes, but not really. The problems would be many, including:

1. Physical layout. Finding one with the same Input/output connector layout

at the back would be very difficult.

2. Onboard connectors. The front panel wires for the onn/off switch and hard

disk/power LEDs go to a single connector designed to fit the pins on the

current board. So, unless you feel comfortable cracking connectors or

re-splicing wires, don't try it.

3. Power Supply connectors on earlier models may be proprietary.

So, generally speaking for most users, the board is NOT easily upgradeable.



Q) How do I prevent getting Blue Screens or freezeups while using the Compaq
DVD player?

A) Look for a file named SCSI1HLP.VXD(or SCSIHLP.VXD) in the
Windows\system\iosubsys


directory. If there, rename it toSCSI1HLP.OLD, then reboot.



Q) Is there a different or later BIOS for my Compaq that allows more
adjustments?

A) The only BIOS updates that are safe for your Compaq are those listed for
your specific model on the


Compaq/HP website. Occasionally, a BIOS update from Compaq will provide a
few new settings, but


not as a general rule. Installing any other is risky and may render your
Compaq unbootable.



Q) Is my Compaq Compatible with Windows XP?

A) There is a compatibility app on the MS site. It attempts to examine all

installed hardware and software and to let you know if you might have a

problem. It's fairly conservative and may warn about things that might later

prove to be trouble-free.



http://www.microsoft.com/windowsxp/p...ng/advisor.asp



Also check to see if the Compaq website has XP drivers posted for your
model.



Q) How can i uninstall MSN Messenger on my Windows XP Compaq? It does not
show up in Control


Panel, Add/Remove Programs, Windows Components.

A) To make it visible, you first must make a slight change in Sysoc.inf in
the C:\Windows\Inf directory.


The line now reads:



msmsgs=msgrocm.dll,OcEntry,msmsgs.inf,hide,7



make it read:



msmsgs=msgrocm.dll,OcEntry,msmsgs.inf,,7



In other words remove "hide" from the line. Then be sure to save the file,
exit notepad, then go to control


panel and it will be visible so you can uncheck the box to uninstall it,
which merely removes the entries


for it from the registry. It does not remove the folder from C:\Program
files.

You can always reinstall by going back to Control Panel, Add/Remove
Programs, Windows


Components and rechecking the box.




 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Compaq FAQ HH Compaq Computers 0 August 1st 03 09:24 PM
Compaq FAQ HH Compaq Computers 0 July 20th 03 03:09 PM
Compaq FAQ HH Compaq Computers 0 July 10th 03 08:07 PM
Compaq FAQ HH Compaq Computers 3 July 8th 03 05:14 AM
Compaq FAQ Updated HH Compaq Computers 0 June 29th 03 03:58 PM


All times are GMT +1. The time now is 02:11 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.