|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 15th 03, 10:19 PM
|
|||
|
|||
config a compaq array 3200 in a non compaq pc?
How can I install a Compaq smart array controller 3200 on a non-Compaq
machine? I recently acquired (was exchanged for an old computer) a Compaq smart array controller and some drives. All the installation instructions for it refer to using the Compaq smartstart utility. However this won't work on a non-Compaq machine, and when I power on the PC I get an error msg saying that the array is not configured. What can I do to get it working as the boot array for a W2000 installation? Thanks. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RAID Array "Off Line" on P4C800-E Deluxe | macleme | Asus Motherboards | 4 | September 1st 04 07:22 PM |
| help with motherboard choice | S.Boardman | General | 30 | October 20th 03 10:23 PM |
| help with motherboard choice | S.Boardman | Overclocking AMD Processors | 30 | October 20th 03 10:23 PM |
| Compaq FAQ | HH | Compaq Computers | 1 | August 7th 03 11:24 PM |
| Compaq FAQ | HH | Compaq Computers | 0 | August 1st 03 09:24 PM |
Threaded Mode