If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Application to Position Applications to Different Monitors?
Does ATI make any application that would automatically position different
applications to different monitors? For simulation under FS2004, I want to use discrete applications simulate flight instruments and connect to the FS2004 application using TCP/IP. When I start these applications I want a way to automatically associate them with different output windows. -- Will westes AT earthbroadcast.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
writing cd`s | biggmark | Cdr | 7 | December 31st 04 09:57 AM |
Getting an Enrty-Level Position | Christopher Kurtis Koeber | General | 3 | June 20th 04 02:26 AM |
FIC or HIS for a 9600Pro? | Phrederick | General | 8 | December 16th 03 01:17 PM |
FIC or HIS for a 9600Pro? | Phrederick | Ati Videocards | 8 | December 16th 03 01:17 PM |
New XP Install on D:Drive Keep Applications & Data on C: Drive | Dennis | Homebuilt PC's | 4 | October 4th 03 08:15 PM |