If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
BC-02 external blocking
The print quality of my bc-02 was suffering, banding, weak print etc.
I noticed that the bottom of the inkjet had a lot of dried ink on it. Has anyone any tips for keeping this area clean. I can clean it manually, but it should be self cleaning. thanks s |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
On the brink of madness... | I.C. Koets | General | 18 | January 31st 05 10:49 PM |
Updrade PC | Guy Smith | General | 22 | August 15th 04 01:57 AM |
external hard drive/ partitioning | marvin | General Hardware | 4 | February 14th 04 12:54 AM |
Maxtor External 3000LS External Hard Drive Installation | Sam Hollenbeck | General Hardware | 1 | February 7th 04 02:50 PM |