|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 10th 04, 11:20 PM
|
|||
|
|||
FX5200 and PcChips board
I have just assembled a new PC and used a PcChips M848ALU board and an
nVidia GeForce FX5200 128Mb DDR And it keeps crashing on start up every time I put the cards drivers in. A very fast sign comes and goes which I have finally seen and it says ''input signal is out of Range'' and ''please change signal timer'' Help please des --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.736 / Virus Database: 490 - Release Date: 09/08/2004 
|
|
#2
August 11th 04, 12:07 AM
|
|||
|
|||
|
It sounds like the scan frequency for your monitor, is set too high.
Possibly you have a LCD panel? If so, boot into Safe Mode, go into your video card properties, and set the scan rate to 60Hz. Re-boot. Bill Crocker "Des" wrote in message ... I have just assembled a new PC and used a PcChips M848ALU board and an nVidia GeForce FX5200 128Mb DDR And it keeps crashing on start up every time I put the cards drivers in. A very fast sign comes and goes which I have finally seen and it says ''input signal is out of Range'' and ''please change signal timer'' Help please des --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.736 / Virus Database: 490 - Release Date: 09/08/2004
|
|
#3
August 11th 04, 10:49 PM
|
|||
|
|||
|
I just rebuilt my system with a M848A from Ebuyer
and it was locking up in games. Ive downloaded a newer AGP driver than the one on the disc and dropped the AGP speed from 8x to 4x and its seems better. Not the most stable board Ive used and my first experience with SiS chipsets. "Des" wrote in message ... I have just assembled a new PC and used a PcChips M848ALU board and an nVidia GeForce FX5200 128Mb DDR And it keeps crashing on start up every time I put the cards drivers in. A very fast sign comes and goes which I have finally seen and it says ''input signal is out of Range'' and ''please change signal timer'' Help please des --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.736 / Virus Database: 490 - Release Date: 09/08/2004
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
