If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Promise TX2 Ultra causes hang on boot
Anytime I install the Ultra 133 TX2 card in my HP Vectra VL5 Series 3 it
hangs on boot up when the card should be searching for the hard drive. I have tried different PCI slots with no luck. I tried the following BIOS settings: PNP Initialization: FULL and OFF IDE controller: INTEGRATED and CONTROLLER CARD Still same results. There are other BIOS settings for: SCSI BIOS ROM ADDRESS SCSI BIOS SHADOWING that I cannot change for some reason. Please let me know what I should try to get the card working. Thanks, Charlie |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Frequent hang! | philo | General | 4 | October 10th 06 12:11 PM |
Hard drive that boots elsewhere refuses to boot in this machine | Simon O'Connor | General | 9 | July 22nd 03 06:34 AM |
Computer won't boot with 2000+ Athlon, 2100+ Athlon works just fine | Cyde Weys | General | 4 | July 3rd 03 12:16 PM |
Promise Ultra 100 | S. Pfeffer | General | 6 | June 29th 03 07:26 PM |
Help! Notebook Won't Boot | °Mike° | General | 1 | June 27th 03 12:13 AM |