A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals » General
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

strange problem with hard drive



 
 
Thread Tools Display Modes
  #1  
Old January 1st 04, 02:36 PM
James
external usenet poster
 
Posts: n/a
Default strange problem with hard drive

I have a 30GB Western Digital EIDE hard drive. Model: WD300BB ... Params:
LBA 58633344 ... It has an Active Primary partition (c20GB) and an extended
partition with one logical drive(c10GB). My symptons are as follows...

1) BIOS either takes a very long time recognising the drive or it fails to
but windows will still see the logical drive.
2) DOS cannot see the hard drive
2) I can access the logical partition from windows but not the Primary
partition. (I added this drive to another system)
3) Partition magic does not recognise the drive


I would ideally like to able to diagnose this, but am rather stuck. I have
checked all regular causes such as primary drive being hidden, bad ide
cables and tried hd on other systems... I would say that it's time to ditch
the drive but would at least like to know what has caused this -

tia


  #2  
Old January 1st 04, 03:11 PM
philo
external usenet poster
 
Posts: n/a
Default


"James" wrote in message
...
I have a 30GB Western Digital EIDE hard drive. Model: WD300BB ... Params:
LBA 58633344 ... It has an Active Primary partition (c20GB) and an

extended
partition with one logical drive(c10GB). My symptons are as follows...

1) BIOS either takes a very long time recognising the drive or it fails to
but windows will still see the logical drive.
2) DOS cannot see the hard drive
2) I can access the logical partition from windows but not the Primary
partition. (I added this drive to another system)
3) Partition magic does not recognise the drive


I would ideally like to able to diagnose this, but am rather stuck. I have
checked all regular causes such as primary drive being hidden, bad ide
cables and tried hd on other systems... I would say that it's time to

ditch
the drive but would at least like to know what has caused this -

tia



since you are using it as a 2nd drive, the primary partition should not
be set active.

the drive is not necessarily bad...but your bios seems to have trouble
detecting it.
you may want to try setting the parameters manually


  #3  
Old January 1st 04, 04:00 PM
James
external usenet poster
 
Posts: n/a
Default


"philo" wrote in message
...

"James" wrote in message
...
I have a 30GB Western Digital EIDE hard drive. Model: WD300BB ...

Params:
LBA 58633344 ... It has an Active Primary partition (c20GB) and an

extended
partition with one logical drive(c10GB). My symptons are as follows...

1) BIOS either takes a very long time recognising the drive or it fails

to
but windows will still see the logical drive.
2) DOS cannot see the hard drive
2) I can access the logical partition from windows but not the Primary
partition. (I added this drive to another system)
3) Partition magic does not recognise the drive


I would ideally like to able to diagnose this, but am rather stuck. I

have
checked all regular causes such as primary drive being hidden, bad ide
cables and tried hd on other systems... I would say that it's time to

ditch
the drive but would at least like to know what has caused this -

tia



since you are using it as a 2nd drive, the primary partition should not
be set active.

the drive is not necessarily bad...but your bios seems to have trouble
detecting it.
you may want to try setting the parameters manually



the drive is not active in the second system, it is not on the primary ide -
it is on the secondary, - params have been set manually and still the same
problem - I ran Western Digitals diag disk and it says that 'the bios is not
controlling this disk' - now I would like to know if this is refering to the
drives bios or the motherboards? - I would presume the drives as same
problem occurs on different systems. Is there a way to upgrade the firmware
on the drive - as it seems that it could be the problem - what are your
thoughts?

thanks


  #4  
Old January 1st 04, 04:17 PM
philo
external usenet poster
 
Posts: n/a
Default

snipped

the drive is not active in the second system, it is not on the primary

ide -
it is on the secondary, - params have been set manually and still the same
problem - I ran Western Digitals diag disk and it says that 'the bios is

not
controlling this disk' - now I would like to know if this is refering to

the
drives bios or the motherboards? - I would presume the drives as same
problem occurs on different systems. Is there a way to upgrade the

firmware
on the drive - as it seems that it could be the problem - what are your
thoughts?



Assuming you are using win9x... a 2nd harddrive does not require
the bios to detect it...windows will see the drive ok without the bios.
So what you've described...I've definately seen before. The reason partiton
magic does not see the drive is because PM does require the bios seeing it.
The primary partition might be NTFS perhaps and thus invisible to win9x?

Anyway, I would not give up on the thing yet. Try seeing if the bios
can detect the drive with no other drive in the machine. You may want to
also try auto detect...or different jumper settings etc.

as a last resort, you may want to try installing drive overlay software such
as EZ Bios. I know I have had to use it before when I;ve had problems with
the bios detecting the drive


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Multi-boot Windows XP without special software Timothy Daniels General 11 December 12th 03 06:38 AM
Hard drive problem MyndPhlyp General 1 November 12th 03 12:39 AM
Help! WinXP can't tell that my 2nd hard drive is already formatted FitPhillyGuy General 12 September 26th 03 03:38 AM
Seagate Hard Drive - Faulty? Mike Walker General 2 September 5th 03 02:06 AM
Hard drive that boots elsewhere refuses to boot in this machine Simon O'Connor General 9 July 22nd 03 06:34 AM


All times are GMT +1. The time now is 04:38 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.