If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
JNI or Emulex for 1G Fibre Channel HBA?
I apparently have a defective JNI FC64-1063-MC-EMC controller because it
always reports LINK DOWN and I see continuous messages in the log stating "Tachyon Hung - Resetting". Needless to say, the card won't communicate with anything. I chose the JNI because it appeared to be the most commonly used link between a Sun w/ Sbus and a Clariion DPER on an FC5700. Now I see that JNI has been bought out by a company called AMCC. That usually happens to under-performing companies. I've been told that Emulex is equal to Qlogic and quite possibly better - they seem to be the Cadillac of Fibre Channel HBA's. I also see that the Emulex LP8000S is a common choice given my hardware. Anyone have a preference? The JNI's are certainly cheaper and plentiful so I'd really like to know if there's real issues with JNI or if I just had bad luck with my first one. Any help is appreciated. Charles McCane Dallas, TX. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FA Fibre Channel Hardware | Tom Olson | Compaq Servers | 1 | February 6th 04 07:34 PM |
FA Fibre Channel Hardware | Tom Olson | Compaq Computers | 0 | February 4th 04 10:49 PM |
FA Fibre Channel Hardware | Tom Olson | Storage & Hardrives | 0 | February 4th 04 10:31 PM |
Fibre Channel Hub | Rico | Storage & Hardrives | 0 | January 9th 04 11:06 AM |
Fibre Channel, QLA2200F as networking device | Mark H. | Storage & Hardrives | 5 | November 14th 03 09:22 PM |