|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
The intergrated firewire port on the 8500DV is processed through the video
card itself. It is highly possible that your motherboard doesn't support
IRQ Steering/ Shared IRQs. The board doesn't have to support firewire just
only to have the resources to use the card.
Check your System Information to see if your motherboard is using Shared
IRQs by going into 'System Information' --- 'Hardware Resources' ---'
Conflicts/Sharing' and also 'System Information' -- 'Hardware
Resources' -- 'IRQs'. Check to see which IRQ's are in use and how many
times (if any) of each are used.
Hope this helps
"My reality is perceived by my experiences"
"J" wrote in message
I have the same issue with one of my computers running XP Pro. It's an
system running a PII 350. I do think it is an older motherboard that
"Sgt Andrew" wrote in message
I have the AIW 8500 DV running WinXP. In device Manager there is a
exclamation point for the Firewire/1394 controller. It says "This device
find enough free resources that it can use. (Code 12).I have no other
the machine except the 8500DV
Does anyone no of a fix for this or did I get screwed by ATI.
|Thread||Thread Starter||Forum||Replies||Last Post|
|pc problems after g card upgrade + sp2||ben reed||Homebuilt PC's||9||November 30th 04 02:04 AM|
|Firewire 1394 not working since XP SP2||Bubba||Asus Motherboards||12||November 9th 04 02:46 PM|
|Firewire harddrive speeds||Erwin R. Leijen||General||1||October 1st 04 02:09 PM|
|1394 Firewire + DV on A7N8X-E Deluxe + XP?||skookum||Asus Motherboards||10||September 3rd 04 11:07 PM|
|ASUS P4C800-E Deluxe: Warning, onboard Firewire may have fried my components, details inside...||Z Man||Asus Motherboards||9||December 11th 03 04:34 PM|