If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Proliant 800 Hot swap drive cage
I have just acquired a Compaq Proliant 800 with a 400 MHz PII.
I would like to know if I can replace the standard non hot swap drive cage with a Hot swap cage from a Proliant 1600? If yes is it just a matter of plugging in the cage? James |
#2
|
|||
|
|||
Yes, you can. I did it myself with my own PL800
you will need to drill the riverts out that hold the non-HS cage in place. Then, remove and put the cage in from the 1600 and secure with T-15 screws. - LC "js go-airinc.com" jmsmith@removeme wrote in message ... I have just acquired a Compaq Proliant 800 with a 400 MHz PII. I would like to know if I can replace the standard non hot swap drive cage with a Hot swap cage from a Proliant 1600? If yes is it just a matter of plugging in the cage? James |
#3
|
|||
|
|||
Thank you.
"NuTCrAcKeR" wrote in message ... Yes, you can. I did it myself with my own PL800 you will need to drill the riverts out that hold the non-HS cage in place. Then, remove and put the cage in from the 1600 and secure with T-15 screws. - LC "js go-airinc.com" jmsmith@removeme wrote in message ... I have just acquired a Compaq Proliant 800 with a 400 MHz PII. I would like to know if I can replace the standard non hot swap drive cage with a Hot swap cage from a Proliant 1600? If yes is it just a matter of plugging in the cage? James |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to test psu and reset to cmos to default | Tanya | General | 23 | February 7th 05 09:56 AM |
Norton Ghost - Clone Won't Work | jimbo | Homebuilt PC's | 70 | November 15th 04 01:56 AM |
Need HELP - Can Not Get QR discs to Work | Steve | Compaq Computers | 16 | May 26th 04 12:04 PM |
Help... | Gene Puhl | Homebuilt PC's | 3 | April 10th 04 02:16 AM |
help a oldtimer | Vasko Altiparmakov | Overclocking | 12 | December 3rd 03 02:06 PM |