If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Emaching bad power suppy
I have a friends PC at my house to check out. It would not boot, no
activity, (Power supply fan not turning) no post no nothing. I had a 235 watt power supply laying around and replaced the 250 watt that was in the PC. The 235 I put in powers up but still no post, no beeps, no nothing. Is it possible that the 235 is not enough watts? I also disconnected the 2 cd drives and just left the HD and floppy connected, still no post or beeps. Thanks, Brian |
#2
|
|||
|
|||
Both learn how the power supply 'system' works AND identify
the failed part before swapping anything. Previously posted are "Computer doesnt start at all" in alt.comp.hardware on 10 Jan 2004 at http://tinyurl.com/2t69q and "I think my power supply is dead" in alt.comp.hardware on 5 Feb 2004 at http://www.tinyurl.com/2musa Takes a long time to read. Procedure can determine the problem in but minutes. Notice the 'system' has handshaking between PSU and controller. The 'system' is composed of three components. Brian Cloutier wrote: I have a friends PC at my house to check out. It would not boot, no activity, (Power supply fan not turning) no post no nothing. I had a 235 watt power supply laying around and replaced the 250 watt that was in the PC. The 235 I put in powers up but still no post, no beeps, no nothing. Is it possible that the 235 is not enough watts? I also disconnected the 2 cd drives and just left the HD and floppy connected, still no post or beeps. Thanks, Brian |
#3
|
|||
|
|||
There is a red light on the motherboard that is on and the power supply fan
as well as the CPU fan. That is all that will work. I hooked up an extra hard drive to one of the connecters and it spun up fine. Took out video card to try a get some beeps still nothing. Is it worth it to try another PS? May a 350? Thanks Brian "w_tom" wrote in message ... Both learn how the power supply 'system' works AND identify the failed part before swapping anything. Previously posted are "Computer doesnt start at all" in alt.comp.hardware on 10 Jan 2004 at http://tinyurl.com/2t69q and "I think my power supply is dead" in alt.comp.hardware on 5 Feb 2004 at http://www.tinyurl.com/2musa Takes a long time to read. Procedure can determine the problem in but minutes. Notice the 'system' has handshaking between PSU and controller. The 'system' is composed of three components. Brian Cloutier wrote: I have a friends PC at my house to check out. It would not boot, no activity, (Power supply fan not turning) no post no nothing. I had a 235 watt power supply laying around and replaced the 250 watt that was in the PC. The 235 I put in powers up but still no post, no beeps, no nothing. Is it possible that the 235 is not enough watts? I also disconnected the 2 cd drives and just left the HD and floppy connected, still no post or beeps. Thanks, Brian |
#4
|
|||
|
|||
Brian Cloutier wrote:
I have a friends PC at my house to check out. It would not boot, no activity, (Power supply fan not turning) no post no nothing. I had a 235 watt power supply laying around and replaced the 250 watt that was in the PC. The 235 I put in powers up but still no post, no beeps, no nothing. Is it possible that the 235 is not enough watts? I also disconnected the 2 cd drives and just left the HD and floppy connected, still no post or beeps. Maybe the first PSU fried because the mobo became bad (capacitors leaked or bulged -- see www.motherboardrepair.com) or shorted against the case. PSUs in major brand computers are normally really high quality and can't be damaged by the mobo, but eMachines seems to be an exception and sometimes uses even Powmax PSUs, which are among the worst. If the HD spun up, it probably means that the +12V and +5.0V rails are OK, so that leaves the +3.3V rail in question, but I have a feeling that it's OK, too, although I had a cheapo PSU where only it failed (when a memory module plugged in backwards). A voltage meter will tell you for sure, and even the cheapest digital one (not analog) is very accurate. That 235W PSU is probably powerful enough, at least for testing the mobo without any CD or hard drives connected, unless it's a realy bad brand. What brand is it, anyway? |
#5
|
|||
|
|||
The 235 watt is an a-open. The original PS did not fire up at all. At
least the 235 spins the fans. However it did not power up the cd drives or the floppy. I am begining to wonder if the original PS took out more than the MB? Brian That 235W PSU is probably powerful enough, at least for testing the mobo without any CD or hard drives connected, unless it's a realy bad brand. What brand is it, anyway? |
#6
|
|||
|
|||
Brian Cloutier wrote: The 235 watt is an a-open. The original PS did not fire up at all. At least the 235 spins the fans. However it did not power up the cd drives or the floppy. I am begining to wonder if the original PS took out more than the MB? A-open is really, really good and probably more powerful than your 250W or even some 300W PSUs. I don't understand how the HD could run but the floppy and CD drives wouldn't because they all operate off the same +12V and +5V rails. Do the CD drive trays open when you press their buttons? I think that the MB took out the original PS rather than the other way around. You'll have to measure the voltages for the CPU core, memory slots, PCI slots, etc., to see what's still working. |
#7
|
|||
|
|||
I was walking down the street, minding my own business, when on Sun,
9 Jan 2005 11:52:40 -0600, "Brian Cloutier" screamed from behind the mulberry bush: I have a friends PC at my house to check out. It would not boot, no activity, (Power supply fan not turning) no post no nothing. I had a 235 watt power supply laying around and replaced the 250 watt that was in the PC. The 235 I put in powers up but still no post, no beeps, no nothing. Is it possible that the 235 is not enough watts? I also disconnected the 2 cd drives and just left the HD and floppy connected, still no post or beeps. It's more likely the cheap ass mobo in the E-machine was fried by the PS as it died. Time to get a new machine, not worth fixing. |
#8
|
|||
|
|||
Thanks for the post. The original PS was dead. The A-open I tried worked
but MB did not respond. "Brian Cloutier" wrote in message news I have a friends PC at my house to check out. It would not boot, no activity, (Power supply fan not turning) no post no nothing. I had a 235 watt power supply laying around and replaced the 250 watt that was in the PC. The 235 I put in powers up but still no post, no beeps, no nothing. Is it possible that the 235 is not enough watts? I also disconnected the 2 cd drives and just left the HD and floppy connected, still no post or beeps. Thanks, Brian |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PC Power Consumption, Measured Numbers | Andy | General | 3 | August 28th 04 02:19 AM |
basic power problem | BrianBloodaxe | General | 19 | July 26th 04 08:48 PM |
Is power for Duron nealry all at 12 volts? | kony | General | 3 | April 7th 04 12:35 AM |
How can I make motherboard to restart after power loss automatically? | Amiran | General | 1 | September 24th 03 11:35 PM |
how to give energy to USB devices? with notebook off!!! | andrea rossi | General | 10 | September 12th 03 08:54 PM |