If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Geforce2 MX and DVI Problem
Hi all - I'm nearly at my wit's end here . . . any help would be
greatly appreciated! I'm having problems trying to display XGA (1280x1024) through the DVI output from my Nvidia GeForce2 MX video adapter. I have a Sony Vaio with an Nvidia GeForce2 MX (w/32MB video memory) running Windows ME (don't ask) I recently upgraded from my Samsung 1024x768 display to a new BenQ FP17E+ which runs at a native resolution of 1280x1024. It has both VGA analog and DVI inputs. I was running my Samsung monitor via the DVI output of the display adapter (after having updated the driver way back when). I attached the new BenQ monitor and installing the monitor's driver (profile) that came on CD. The system seems to correctly recognize the new monitor (as reported by the display control dialog). The Problem ----------- When I run the display via the *analog* VGA output of the display adapter, it works fine (I can go up to the full 1280x1024 resolution). However, when I use the display settings to select the DVI output of the adapter, it does not allow me to select up to the native 1280x1024 resolution. So, I updated the driver to the latest Forceware driver, version 77.72. It has the same issue. Then, I tried installing an earlier revision, "Detonator" driver version 30.82 and that actually showed 1280x1024 as an available resolution. However, when I selected it and it did the 15 second screen test, the screen went blank. So, now I am left having to drive the display via the VGA analog output which is maybe not the worst thing in the world, but I'd like to get the DVI ouput working. Any advice would be greatly appreciated. Thanks, -MB |
Thread Tools | |
Display Modes | |
|
|