|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 7th 04, 03:10 PM
|
|||
|
|||
GA-7N400 PRO 2 rev.2 questions
I am running a 3200+ on this board with a single 80 gig drive cinnected to
the ITE RAID controller. It is a fast and reliable system but I have a few questions. Device Manager shows the built-in Realtec network adapter (which I am using) and also a 1394 network adapter. I am not sure what this second adapter is or how to use it. I have the 1394 firewire port enabled but have not used it. The ITE RAID controller is installed and configured properly in Device Manager but if I try to open the RAID manager, I get a stop screen and reboot. Could this be because there is only one drive attached? My only complaint with this board so far is that due to a capacitor placed too close to the ZIF socket, I could not use the heatsink I wanted. The CPU temp never goes over 51C so it is not a problem. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| K8V SE Questions | William | Asus Motherboards | 9 | April 10th 04 10:09 AM |
| Newbie questions on overclocking Mobile AMD 2400+/266 Athlon XP with A7N8X-E Deluxe rev.2 | Arawak | Overclocking AMD Processors | 2 | March 10th 04 08:30 PM |
| Difference between 7N400 PRO /7N400 PRO Nforce2 | [email protected]\(news\) | Gigabyte Motherboards | 1 | November 24th 03 04:47 PM |
| GA 7N400 Pro - memory and sound advice please | LiveWire | Gigabyte Motherboards | 0 | August 21st 03 11:47 PM |
| serial ATA vs ATA133...can't decide on wich...to much unanswered questions... | KILOWATT | General | 2 | July 12th 03 10:13 AM |
Threaded Mode