If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Does ieee-1394 have to be enabled on a A7v8x?
Just installed a RMA'ed A7v8x and the firewire port doesn't work. I never had a firewire device before so I never tried it on the old board. The camcorder works on my A7v333 so the camera isn't the problem. The A7v333 has a jumper to enable the firewire connector, but I can't find anything in the A7v8x manual about enabling the jumper on it. Did I miss it, or do I need to Re RMA the board? Thanks, Tom Just checked my device manager and it's listed there. I didn't do any enabling but believe I did install the drivers off the CD. Win98SE _________________________ When your PC gives a little they give alot: http://tinyurl.com/hhez |
#2
|
|||
|
|||
Hi,
What does device manager show? Tony TommyD wrote: Just installed a RMA'ed A7v8x and the firewire port doesn't work. I never had a firewire device before so I never tried it on the old board. The camcorder works on my A7v333 so the camera isn't the problem. The A7v333 has a jumper to enable the firewire connector, but I can't find anything in the A7v8x manual about enabling the jumper on it. Did I miss it, or do I need to Re RMA the board? Thanks, Tom |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
IEEE 1394 problem | Skjoldmø | Homebuilt PC's | 2 | January 28th 04 06:57 AM |
Network ieee 1394 question | Jeff B | Overclocking | 2 | November 18th 03 05:46 PM |
OHCI Compliant IEEE 1394 Problem | CSM | Homebuilt PC's | 2 | October 24th 03 12:11 PM |