If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help OC'ing 2.4c 800 fsb in Abit IC7-G
I've overclocked a couple of Abit machines before but I'm not sure where
to start with this one that I've just put together. I'm hoping for 3.0ghz but I ran out of money for the graphics card and I hope that won't kill my chances. Below is what I'm working with. 1. Abit IC7-G MB 2. 2.4c pent 4 800fsb 3. 2 sticks of matched Corsair DDR400 XMS3200 4. Abit Siluro FX5200 8x 128 mb Thanks for any help Larry Webb |
#2
|
|||
|
|||
"Larry Webb" wrote in message ... I've overclocked a couple of Abit machines before but I'm not sure where to start with this one that I've just put together. I'm hoping for 3.0ghz but I ran out of money for the graphics card and I hope that won't kill my chances. Below is what I'm working with. 1. Abit IC7-G MB 2. 2.4c pent 4 800fsb I have the 533FSB version of that 3. 2 sticks of matched Corsair DDR400 XMS3200 Same ram (but only 1 stick) 4. Abit Siluro FX5200 8x 128 mb And I have worse -- GeForce 4 MX 440-SE (DDR333) Thanks for any help Larry Webb Don't worry, I think your chances of hitting 3GHz are fine. I have a worse graphics card and have no problems at 2.95GHz. Because you have the 800MHz version, I expect your overclocking experience to be even better (because of the low multiplier which you have, since you have the slowest available 800MHz processor). You should be fine. Just make sure to keep your PCI settings at 33MHz and your AGP settings at 66MHz. Don't expect the corsair ram to overclock much, mine only went up about 10MHz (but my next divider setting would set it at DDR436, so I wasn't surprised by that, a 36MHz increase on RAM is a bit much). -- MiniDisc_2k2 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Abit KV8 Pro | Wad | AMD x86-64 Processors | 3 | July 31st 04 05:25 PM |
Last/Fastest cB0 stepped 'gray zone' Celerons work natively on Abit ZM6/BM6? | pgtr | General | 15 | July 9th 04 07:29 PM |
Abit KV8-MAX3 board | Dgoner | AMD x86-64 Processors | 0 | March 19th 04 06:32 AM |
Im pissed at ABIT ! Continuing ABIT kx7-333R woes | [email protected] | General | 2 | January 3rd 04 07:54 AM |
Cant get 2.4C to 3ghz....any ideas..? | Mark Grant | Overclocking | 7 | July 6th 03 01:51 AM |