If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Swapping Hard Drive Positions in DL380 G3
An admin here accidentally installed the boot device for Windows 2003 in
SCSI ID 5 and 6, and a secondary device in SCSI ID 0 and 1, in a DL380 G3 using SmartArray 5Si. What will happen if we power down, swap positions of the four drives, and restart? Will the controller be smart enough to re-assign the drives to the new slots without losing information, or will it attempt to reinitialize them? -- Will |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Several issues in one | playstation60 | Homebuilt PC's | 11 | August 12th 06 07:09 AM |
how to test psu and reset to cmos to default | Tanya | General | 23 | February 7th 05 09:56 AM |
How to install 2nd HDD with Partition Magic 6.0 partitions under Windows ME? | Phred | Dell Computers | 13 | February 18th 04 08:45 AM |
FDISK, HDD #s, don't know how to install two HDDs. | sunslight | Storage (alternative) | 14 | October 29th 03 07:56 PM |