I'll go for 2.2 Ghz


--
"Duct tape is a lot like the Force. It has a Dark side, a Light side, and it
holds all the pieces of the Universe together"
"Harry C" wrote in message
...
I didn't know you were waiting for a reply. Your board has a VIA K8T800
chipset. There are no PCI/AGP locks on it. My research shows that you
won't
get much higher than 2.3ghz out of it, no matter what the the cooling is.
Good luck.
Harryc
--

"Daniel P" wrote in message
news:boq9c.38613$cx5.21220@fed1read04...
Here's my System
AMD Athlon 64 3000+
MSI K8T-NEOFS2R
Kingston 512 PC3200
Nvidia eVGA 5900SE 128
Maxtor 80Gb ATA 7200Rpm
Sound Blaster Audigy 2 ZS
Antec 300W PSU


--
"Duct tape is a lot like the Force. It has a Dark side, a Light side,
and
it
holds all the pieces of the Universe together"
"Harry C" wrote in message
...

"Daniel P" wrote in message
news:r4j9c.36819$cx5.14594@fed1read04...
yep my MSI has it. Anyway well i was thinking about water cooling
because
I
wanted to get into overclocking. like bring my 3000+ up to 3Ghz
without
breaking 50C. Before u say it. The compressor is a little too
expensive
and
I can't find where to buy it.

--
"Duct tape is a lot like the Force. It has a Dark side, a Light side,
and
it
holds all the pieces of the Universe together"
"General Schvantzkoph" wrote in message
news On Sat, 27 Mar 2004 15:36:38 +0000, Povl H. Pedersen wrote:

In article , K wrote:
On Fri, 26 Mar 2004 17:48:46 -0700, Daniel P wrote:

Is anybody running a watercooling system. With the AMD 64. How
much
does it
make your cpu cooler.

I don't but I sometimes wonder if it's worth it on an AMD64
system.
The
chips aren't hot to begin with, and with Cool'nQuiet enabled the
fan
speed
is minimal and can even shut off if the CPU is completely idle.
From what I've seen water cooling doesn't seem to help
overclocking
headroom much either..

Is cool&Quiet something all motherboards can do ? Haven't seen
my cheap FIC board do it.

From the reviews that I've read the answer is no, only a couple of
manufacturers have implemented it. You should check for a BIOS
update
to
see if FIC has added it.



What board do you have Daniel?. 3.0 Ghz is unlikely even with a
compressor
because there are no PCI/AGP locks on most boards out there. NF3-250
boards
coming out now will have locks. I run a mild overclock on an ASUS K8V
*2.2Ghz with a 3000+. This is on water using a Corsair Hydrocool. My
CPU
idle temp is 29*c and load is 34*c. Once I get a board with locks we'll
answer your question, but for now.... If you have any questions about
the
Hydrocool, let me know.
Harryc
--