View Single Post
  #5  
Old March 17th 05, 03:32 AM
JD
external usenet poster
 
Posts: n/a
Default

Cqtip wrote:

The following link has a picture of the unit. I was looking for a
better picture but this will have to do:

http://www.tweaknews.net/reviews/rw2/img/base.jpg

This is a view from the top; the black half. The back of the unit is
where the cable is attached. The bottom half is gray not seen in this
view.

When viewed from the front (both the top black and bottom gray half's
are visible) and opposite from the back, the LED is mounted inside the
black half, directly in line with the cable in the rear. If it is on you
would have no problem seeing it. It flashes (off & on, to back on) when
any button is pressed on the remote.

Cqtip


Thanks for this description. This is the same unit I have. When I plug
it in, it shows up in Device Manager as ATI Remote Wonder II
Controller. But there's no LED that is on or that flashes. Perhaps
mine is defective, although if that's the case I wouldn't expect it to
show up in Device Manager at all.