I am not familiar with ghost, but with drive image v7 during startup from CD
you can load the same intel raid driver into drive image as you would when
you do a repair install of XP. So when drive image loads it sees the raid
volumes however they are created .

- Tim


"John" wrote in message
t.cable.rogers.com...
Tim wrote:


7. If this does not work as per IAA documentation, then it will likely
fail in the first few seconds, so shut down and create the raid 1
manually and restore the image created in Step 0. onto the raid volume.
Follow the XP repair procedure above so that the raid drivers are
installed into Windows XP.


Will Ghost or drive image see the manually created Intel Raid 1 array?