Should be KR7A-133

"Paul Isaacs" wrote in message
news:wcDpg.2992$%61.474@trndny09...
I don't use this computer much, but when I last turned it on a month ago it
was fine. Turned it on yesterday and got a checksum cmos error on boot up.
It will boot, however, using the system defaults and everything seems to be
ok when WinXP loads. But when I try to make any changes in the bios setup,
the computer goes dead, except for power and fans, and the only way I get
it going again is by clearing the cmos with the jumper.

The only thing I can think of is that the processor speed is not correct,
but when I try to change it like I say, the computer goes dead. Even when
I go into setup and don't change anything, it goes dea and I need to clear
the cmos.

Any ideas?