thank you for your response, mike

I tried several times to flash back to 1007, 1006 or even to 1008. Tried
load defaults before and after flashing.

but still the same..everytime i tweak the bios setting for the CPU/RAM, the
bios recovery function just activated.

If i ignored the bios recovery, power off, on again, an error msg. then
showed 'overclock failed' and i can go into bios to load the defaults.
but not to tweak the setting for the CPU/RAM.

Any idea?



"MikeM" ¦b¶l¥ó
. com ¤¤¼¶¼g...
That does sound like your ROM or circuitry is hosed. Try burning it again
to 1008 or 1007and then LOAD DEFAULTS first and then configure as you
like.

Mike
"Dolp" wrote in message
...
I just spent hours in updating the bios in my P4P800DX board..but
failed...and with terrible experience.

a few days ago i flashed successfully under dos from 1006 to 1007, using
afudos.
I could overclock, adjust the setting of ram, performance mode etc.
without
any problem.

tonite i downloaded the 1008 bios, followed the instructions..but
failed...
after i flashed..it seemed ok..then i went to bios..changed the
settings...

but then...after saving & rebooted, it said bios checksum bad..bios
recovery
then the pc kept searching for floppy & cd rom for bios rom.

then i changed back to old bios 1007, but the problem is, i can't make
any
adjustment in bios to overclock, the setting of ram, performance mode
everytime i made such change, after saving the bios, the pc showed
again:

bios checksum bad...bios recovery

then looked for floppy & cd-rom again!!!!

Pl. help!!

I tried clear the RTC and removed battery, but still the same problem.

Can anyone help!!???