I understand what you say with regard to changing the cl timing but
shouldn't the board detect a 200 MHz bus on the spd or is it normal for it
to detect a lower bus speed when set to auto I like anyone else would assume
a memory problem but as I said in a previous post we have now tried 5
different brands of matched pairs so that pretty much rules memory problem
out though I still wondered if a possible board problem. Do you have some
actual "figure " suggestions with regards to timings and vdimm voltages as a
starting point since if they are wrong it is such a long time to get the
bios to reset by the discharge method once it doesn't boot because gigabyte
in their wisdom thought we didn't need a cmos clear jumper any more