There's only 32-bit PCI slot on the motherboard that would fit the video
card - the rest of the slots are 64-bit PCI/PCI-X.

Outta luck, I guess.

-Andy


Hamman wrote:
"Andy Kuo" wrote in message
news:1099620587.687810@sj-nntpcache-5...

Hello,

Has anyone had experience with using a PCI video card on a S2882? I've
installed a video card in my S2882 and disabled the onboard video (via
jumper), but nothing comes out on the monitor when I boot up. Here is a
summary of the problem:

1. I disable the onboard video through the motherboard jumper.
2. Then I plug the video card into PCI slot #5 (the one at the bottom of
the motherboard) and connect the monitor.
3. When I power on the system, nothing shows up on the monitor (I've made
sure that it is connected to the PCI video card).
4. I've also tried disabling the onboard video through the BIOS menu, but
it does not work either - it successfully disables the onboard video
(nothing comes out of the onboard VGA port), but the PCI video card
doesn't display anything either. I had to clear the CMOS to re-enable the
onboard video output.

Here are the system's specs:

Motherboard: Tyan K8S Pro S2882
BIOS revision: v2.03
Operating system: Red Hat Linux 7.3
PCI video card: PowerColor R92P-LC3 (chipset: ATI Radeon 9250)

I've tested this video card in another computer, and it works - so I'm
sure that the video card is not broken. I would greatly appreciate it if
anyone could help me out with this problem.

Thanks,

Andy




Try the video card in PCI 1 if possible, an old BX Chipset PCChips board i
had would ony use external VGA if it was in there.

hamman