Hi.

I'm trying to substitute the COMPAQ DL380 (G1) Server Mainboard with
my VAX 4000 KA54, NVAX 100MHz Mainboard to get rid of the BA42A Case.

The mechanical rebuilding is simple.
The SCSI devices (4x36GB,Plextor-CDROM und 12/24GB DAT) are identified
and operational. Floppy and IDE-CDROM are disconnected.
The Power supply power connector is easy to discover.

Only the Power supply signal cable (14pin between hot plug power
supply bd and system board) is a mystery. That what I've discovered:

+3.3VS+ black o o black +3.3VS-
+5.1VS+ black o o red +5.0V AUX
key x o black +5.1VS-
ON_STB black o o black ??
PG black o o black ??
?? black o o black ??
?? black o o black ??

S+/S- = Sense. ON_STB = pull to GND for PowerOn. PG = PowerGood.

Maybe even this is wrong.
Any help/assistance on this subject would be greatly appreciated.

-Mike