Raising the voltage on the memory may help. Corsair memory can be run
safely as high as 2.8 volts. You shouldn't need to go that high, however,
unless you are overclocking.
David P.
"Aaron Grizzle" wrote in message
news:ktvzc.4791$0z6.1567@fed1read07...
Yes Hal9000 is right on. Clear CMOS and fool around with the memory
timings.
I have a similar setup as your. Abit IC7-Max 3, 1 gig of corsair XMS
memory
and a 3.0 ghz P4. Now believe it or not, my memory timings were too slow.
I
had to lower them to 2-2-2 for the system to boot and be stable. Hope that
is helpful
Aaron
"Brett" wrote in message
m...
Bought the ABIT IC7-MAX3 MB and am running:
P4 3.0E 800 FSB
Thermaltake Spark 5 CPU fan
ABIT IC7-MAX3
ANTEC TRUE480 ATX RTL
1 Gig Corsair PC3200 (Dual Channel 2 x 512)
AIW 9800 Pro 128MB
2 Seagate SATA drives running the 3114 Drivers in raid 0
DVD-RW NEC-2500A
DVD-ROM NEC
Just upgraded it from a 3.06 533 FSB Processor which worked fine for
almost
2 months. When I put the 800 FSB processor in it crashes to blue screen
just
after XP Pro starts, sometimes saying IRQL_NOT_LESS_THAN_something.....
then
it
reboots. Does this consistently on each reboot, and eventually just
comes
up
with no error at all and usually what looks like a single line error
that
looks like a memory location.
I RMA'd the processor and just received a new one, same problem. I
suspected
a weird software problem as I can boot into XP pro safe mode and it is
reasonalbly stable, hasn't blue screened in there yet. But when I tried
to
just install the xp pro again it gets to the point where it says
starting
windows, after the inital loading of the scsi drivers and it crashes.
I'm
considering RMA'ng the motherboard but want to make sure there isn't
something I can do to make this work.
I have ver 16 of the Abit bios instaled, newest one I'm aware of, and
all
the drivers are up to date.
Any Ideas?
|