Fishface wrote:
A co-worker picked-up one of those Fry's special $200 computers
on Friday to replace his eMachines Celeron 1Ghz dinosaur. It has
an ECS 945GZT-M motherboard which has an x16 PCI-E slot which
is only x4 electrically.
http://www.newegg.com/Product/Produc...82E16813135046
It came with a Celeron D 352 (3.2 GHz) and will have 2 x 512MB ddr2
running dual channel. He might eventually replace the Celeron with a
C2D, since the board supports it.

He likes to play games and would like the best gaming experience
possible under the circumstances. He has a CRT and will likely play
at lower resolutions.

What would be the best card he could get that would not be wasted on
this board's x4 ability? The x4 slot has a maximum bandwidth of about
1000 MB/s, according to what I have read. I was thinking a 7600GT,
then discovered the x4 and figured I'd better ask. Thanks for any help!



What are his three preferred game titles? Get the card that meets all
other criteria and will run those games best.

Do not worry too much about "4x" or "16x" with a single card, the lower
bus speed 533/800MHz will hamper performance enough, but running at low
resolutions (1024x768) will avoid those performance issues, as long as
the card isn't one of those dreaded turbocache cards and thereby
impacted by the less available bandwidth headroom.

That board is a sled and it isn't suitable for high end gaming, say
Oblivion, but I bet it and a 7600GT can run BF2 and other FPS games well
enough.

To put the performance loss of "16x" to "4x" (at moderate resolutions
with correct hardware) to scale, it is greater than the performance loss
of going to CAS5 from CAS4 DDR2, but less than the performance loss of
going to a 533MHz from a 800MHz FSB. How much less varies.