Burt wrote:

BCI-6 tanks don't need to stand for any appreciable period of time after
refilling.

REFILLING IS TROUBLE STANDING OR SITTING

You do need to permit any ink that will drip out of the outlet
port to do so before replacing the cart into the printer.

JUST GIVE IT A GOOD SQUEEZE

If you have a
good seal

HOW ABOUT A WALRUS

on the refill hole the dripping will stop after just a few drops


GETTING ON YOUR CARPET

and will not leak into the printhead.

"Davy" wrote in message
om...


Ron,
I was reading somewhere when refilling it's better to leave standing
for 24 hours prior to using and yet I read you insert them straight
away.

Obviously you fill the tanks nice and slow to avoid getting air into
them and not to over fill, be glad if you clarified the above after
filling as to leaving them to settle.

Davy