BCI-6 tanks don't need to stand for any appreciable period of time after
refilling. You do need to permit any ink that will drip out of the outlet
port to do so before replacing the cart into the printer. If you have a
good seal on the refill hole the dripping will stop after just a few drops
and will not leak into the printhead.

"Davy" wrote in message
m...
Ron,
I was reading somewhere when refilling it's better to leave standing
for 24 hours prior to using and yet I read you insert them straight
away.

Obviously you fill the tanks nice and slow to avoid getting air into
them and not to over fill, be glad if you clarified the above after
filling as to leaving them to settle.

Davy