I have a PATA drive connected to IDE0 master, and one SATA connected
to ICH5R, SATA 0. Both have a bootable W2K partition and boot well if
only on is present. But if both drives are connected the pc alway
boots from the PATA drive. How can I change that? I set OnChip SATA
manual, to SATA0, Raid disabled,. onboard GigaRAID and Onboard SATA
disabled. Bottorder1. floppy, 2. cdrom, 3 HDD-0. There seems to be no
SATA in the bootorder, not even a SATA-RAID or PATA-Raid. Any ideas?
TIA - Klaus

I have 1 SATA drive (Set up as SATA0), and Four PATA on the GigaRAiD channel
plus 3 CD/DVD devices on the normal IDE.

I eventually got it to boot by using the SATAA connectors (The hot pluggable
ones) and removing SCSI from the boot option. I also had to install drivers
for the SATA while it was being used as "IDE3" initially - however I set the
assignment back to AUTO afterwards.

..