View Single Post
  #10  
Old November 27th 04, 01:52 AM
JAD
external usenet poster
 
Posts: n/a
Default

On an ASUS board the splash and audible system monitor were in the
'Boot sequence' page in the bios....your referring to the POST screen
and the 'splash' of the MB manufacturer is covering it?..

I can't recall what they referred to it as, but I remember it was ill
named and made little sense.


"Papa" wrote in message
ink.net...

"Thomas Wendell" wrote in message
...
It's in the BIOS alright. Usually it's called Silent Boot under

Advanced
Options/Settings. Disable that and the normal BIOS screen should

come
up...


--
Tumppi
Reply to group
=================================================
Most learned on nntp://news.mircosoft.com
Helsinki, Finland (remove _NOSPAM)
(translations from FI/SE not always accurate)
=================================================



"Papa" kirjoitti viestissä
ink.net...
I just built a new computer consisting of a Soyo SY-KT600 Dragon

Plus
v2.0
motherboard, 512 MB of memory, an AMD Sempron 2400+ CPU, etc..

The OS is
Windows XP Pro.

The system boots up just fine, and all of the Windows functions

perform
OK.
When I first power the system up, I get the motherboard splash

screen.
However, the next screen I see is the Windows XP screen. The BIOS

screen
never appears.

The BIOS screen is usually loaded with useful information, and I

would
like
to see this info. Is there some way to make the BIOS screen

appear during
boot up?

In case some of you misunderstood my post, I am not talking about

getting
into CMOS. That is easy. All I have to do is press the DEL key

early in
the
boot process. Also, my CMOS has no function listed that can

enable or
disable the splash screen or the BIOS screen, and I have

installed
(flashed)
the most recent BIOS version.

Thank you.





Thanks Tom.

Yes, you would think so, but I had already looked there (and all of

the
other CMOS pages as well, and such a parameter (or anything remotely
resembling it) is just not there. The Advanced page lists the

following:

Quick Boot. I tried both the Enabled and Disabled settings. The only
difference I can see is that when it is disabled the boot takes a

little
longer, but no BIOS screen appears.

The other Advanced page items a

1St boot device, 2nd boot device, 3rd boot device, Try another boot

device,
S.M.A.R.T. Enabled, Num-Lock, Floppy Drive Swap, Floppy Drive Seek,

Password
Check, Boot to OS/2, L2 Cache, System Boot Cacheable (it is

enabled),
Graphic Window size, SDRAM Timing by SPD, SDRAM CAS# Latency, SDRAM

Bank
Interleave, Auto Detect DIMM CLK, and Spread Spectrum.

Do you suppose I need to hit a certain keyboard key during bootup? I

already
tried the TAB key, and all it does is prevent the Soyo splash screen

from
appearing.

Regards.