Ditto , Give it up it will not work unless you swap out the system
board for a System Pro or maybe a DL310 or DL 140 board which does
support ATA raid but will not fit without duct tape and spit and maybe
a hammer and beer

cant be done. that server does not support the int13 thingy that is needed
for IDE controllers to boot with.

give up now...

LC

"Mark S" wrote in message
...
Does anybody know if there is such a thing as a PCI IDE controller,
preferably UDMA 100/133?
Reason.....
I have a Compaq Proliant 5000 running Win2K SVR, and I am trying to put 4
120Gb IDE HDD's in it. I have tried various PCI IDE RAID cards in it, both
with the SCSI Raid controller in and out of it. The only thing that
happens
is: Boot machine, run the config, doesn't detect HDD but does detect the
PCI
card. press F1 to force it to boot, and you get it to run Win setup from
the
CD. It goes all the way through setup before restarting, and then fails
again at boot!
Is there anyway that I can configure the "bios" to accept/ignore the PCI
card but allow Win2K to access it? or create a configuration file for the
Smart setup to use?
Or am I wasting my time????
please bear in mind.... 120Gb IDE HDD =£65 ($100) Very Large SCA HDD =£big

Many thanks for reading, and many thanks in advance

Mark S