"Danny" wrote in message
...
Hi, a little off topic but I'm hoping somebody can give me some
advice. With you overclockers tweaking these over the years you're
probably the best people to ask was my thought!
I've just brought my old PC back from the dead. It had win98 installed
along with some old programs and doc files that I didn't want to wipe.
So I took a chance and just installed a S/H Jetway 531CF mobo that
came with a K6-2 500 3D. I pulled the old mobo out, fitted the Jetway
one, booted up, and apart from a few minor problems with some drivers,
my old system is back up and running!
The BIOS was the same just a later version (AWARD 4.51). Now, nearly
all is well and I can back up some of the files and programs that I
wanted off this system. But now it's working again I may as well get
it working properly and smoothly and keep it just in case as a spare!
So I've just couple of minor issues to do with the K6-2.

On boot-up when I go into the BIOS it's showing the old CPUID which is
Cyrex 6X86. Although when first installed it did show the K6-2 and the
relevant settings. On the memory test at boot-up it shows as the K6 as
well as in windows sys/info it shows also shows as K6-2. It's just in
the BIOS CPUID that the K6 and its settings seem to have got lost!
Any ideas on a solution?
It does seem to run a little slower than I would have expected in
windows, about the same as the old Cyrex did, although the test I've
done in DOS show good results from the K6-2. So I'm hoping that
finding the solution to this will help me to fix that.

Change multiplier to 5.0 and FSB to 100, if you have PC100/PC133 RAM. There
should be charts printed on the MB somewhere. Check your CPU voltage, I
think it should be 2.1V standard,

Apart from that the only other problem is that the system seems to
scrub/corrupt the autoexec.bat on start-up which may or may not be
related.
I've not done as yet a full reinstall of windows as the CD may have
been used as a coaster too many times over the past few years and I
remember, because of scratches, some of the cabs are corrupt!
So I'm hoping to sort out these few problems with out having to do any
sort of reinstall of windows if possible!

Anyway, big thanks if you can help me with this or direct me to a
forum, newsgroup or web-site where I may find some info.

Dave