just for the heck of it i decided to work on a 486 that i had sitting
up in my attic. i have two ISA , SCSI controllers and a few small
SCSI harddrives.

due to too many IRQ conflicts, i had to remove the original ide controller
to get the SCSI controller to work (and it detects the harddrive fine)

however...the floppy drives were also connected to the original ide
controller
but when i connect them to the SCSI controller, they are not detected on
either of the controllers i have.

is there anything special i need to to in order to have the controllers
detect the floppy drives?

philo