On Thu, 03 Jun 2004 05:00:09 -0700, matiii wrote:

Wes Newell wrote in message
news:pan.2004.06.02.07.13.30.421575@TAKEOUTverizo n.net...

.... With
what you have. I'd raise vcore to 1.85 and set the FSB to 133 for
7x133. Easy and should work ok unless the cpu is a dog.

I'm getting really ****ed. Dunno why, hardware totally ignores what I
set in BIOS. No matter if I set FSB to 133, 200 - it always runs 7x100
- WTF!!?!?

Check MB manual. Some boards have to enable the bios control via jumper on
board. I suspect that's what you'fve got.

My Duron has those symbols on its co

D700AUT1B

Which, according to AMD specs means:

D700 obvious, A is a package type - doesn't matter; U - nominal core
voltage - 1.60 V
T - max. die temp. - 90 deg C
1 - level 2 cache size - 64 KB
B - *maximum system bus speed* - *200 MHz*

That's default speed, not maximum.

So? What's wrong? Is BIOS somewhat screwed? Maybe I should flash it, as
someone already has suggested it to me. Or maybe this Duron is too old
to run at higher bus? But I heard of a guy (on #IRCNet, #overclocking)
that runs D600@1000

I could get 1000Mhz out of both my 600 and 700 duron, but not stable.

--
Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB)
http://mysite.verizon.net/res0exft/cpu.htm