To anskwer the question about the broken mirror - you most likely need to
make the new disk dynamic - make sure that is has same device address and
then you have to rebuild the mirror when the disk is recogniced... that
should be all.


Regards


"Pegasus (MVP)" wrote in message
...
You might be wasting your time with your mirrors. These
days, disk failures are fairly rare. When a Win2000 installation
fails, it is in most cases due to some software or setup
problem - which of course is replicated to your mirrored disk!
Disk mirroring might protect you against 5% of all failures,
and will afford no protection at all for the remaining 95% of
all failures.

If you wish to establish a quick recovery method for a failed
server installation then I recommend this approach:
- Use an imaging program such as DriveImage or Ghost to
store an image of the server on your spare disk.
- Keep the spare disk away from the server.
- Update the image file once every two months.
- Keep two versions of the image file: The current one, and
the one before that.


"ck" wrote in message
link.net...
Hi there,

I set up a server for friend. I put the OS on pri-master,
data-secondary
master, then I put an identical drive on secondary slave. I went in to
disc
managment, and mirrored the the secondary drives. Everything worked
cool.
The secondary slave is in a swappable bay. I have a third identical
drive
that I wanted to swap out and have the mirror reestablish every time I
swap.
I broke the mirror, rebooted, and then I thought I could just re-mirror
it.
That optioned is dimmed out. Do I reformat the drive each time and
remake
the mirror set? I am kind of new to raid stuff. Any advice is
appreciated.

tia
~ck