You might want to try updating the firmware on the drive(s) if it's
not jumper related.

Doug


On Fri, 19 Dec 2003 10:45:42 -0600, "nut cracker"
wrote:

typically, that means that they are failed drives. However, I have seen
disks report that they are failed (when they are not) if jumpers have been
set on the disks. The backplane takes care of the SCSI ID's, so there should
be no reason to have any jumpers on the drives.

LC

"sys" wrote in message
. ..
Hi

I have added two harddisk in my Proliant ML370 server. The new disk are
displaying a red harddisk symbol that has an "X" over it. What does that
men? Othervise the disks are working great?

Nic