On Thu, 27 Nov 2003 09:51:31 -0500, Dan Rather
wrote:

Hello,

Is anyone familiar with the Biostar M7NCD motherboard? I am trying to
figure out the jumper settings for the internal speaker. I have looked
at the manual (schematic) and I have the hard drive light and reset
switch correct. It seems that the speaker connects one pin above the
hard drive light on the same side, though the manual might look wrong.
But it does not work. Any input would be appreciated.

Thanks!

If it's as shown in the following pic, looks like positive (usually
red wire) on pin 1, negative (black wire) on pin 7.


http://69.36.189.159/usr_1034/M7NCD_FP.gif