Did you upgrade the CPU too, or are you still using the same CPU chip? If
you are using the original CPU then you really are only getting DDR266 or
maybe DDR333 speeds (320Mhz actually) so you are defeating the whole purpose
of the DDR400 and Dual-channel memory. Also, make certain your DIMMs are in
bank A and one in bank B (same position) or else you will be in
single-channel mode. If you have an "Intel board" going into the BIOS setup
will tell you what speed your memory is running and if you are in
dual-channel or single channel mode.

Ron

"Joseph Lee Jennings" wrote in message
...
Hello,

I have been lurking in the newsgroup but i have hit a wall and wanted to run
this by the experts. We have a form in our paradox 8 application that has 12
buttons with bitmaps and a section of the form is multab with 6 tabs that
are user selected based on the button pressed. the problem i have run in to
is we have been using a intel 850e motherboard with a nvidia gf2 video card
and drivers. recently i switched our hardware to a 865perl motherboard. main
differences between the builds is 850e board was rdram and a 533fsb cpu. the
new board is ddr400 and 800fsb. the old board had no problems with this form
but the new hardware is having a hard time drawing the buttons and tabs.
again this is this one form within our app.
has anyone found a similar problem and fixed it?

thanks to all who respond
Joe