Thread
:
Question on Compaq StorageWorks RAID Array 4100
View Single Post
#
4
July 1st 06, 05:18 AM posted to alt.sys.pc-clone.compaq.servers
Phil
external usenet poster
Posts: n/a
Question on Compaq StorageWorks RAID Array 4100
You can still use the storageworks units with a scsi raid card attached to
your server. Then it could be shared / seen as a conventional drive on the
server. (Some of the storageworks units havea fiber interface, some are
straight scsi.)
A thought,
Phil
"." wrote in message
om.au...
In article ,
says...
There are lots of threads in this group that discuss using those RA4x00
devices.
You cannot connect this to an ethernet switch to get a NAS.
You must connect this to a host server, preferrably using a StorageWorks
FCAL adapter (32 or 64bit). You will nee fibre cable with SC connectors
on
each side. You can have more than 1 system connected to it if you use a
FCAL
hub or switch between the Chassis and your hosts.
The array controller is configured using the conventional ACU from the
smartstart CD, or from within a supported OS.
- LC
Ah so. Thanks, that clears that up - I won't be playing with one of
those then :0
Phil
View message headers