A 1394 *network adapter* ??
AFAIK there is only network adaptor and that is the Realtec. I disabled the
1394 FireWire as I don't use it.

But gee ... you done good. I could not use my choice of HSF because of that
cap and I am running about 61° C.
JPS

"Larry Stone" wrote in message
news:uZTcc.213801$po.1053644@attbi_s52...
I am running a 3200+ on this board with a single 80 gig drive cinnected to
the ITE RAID controller. It is a fast and reliable system but I have a few
questions.

Device Manager shows the built-in Realtec network adapter (which I am
using)
and also a 1394 network adapter. I am not sure what this second adapter is
or how to use it. I have the 1394 firewire port enabled but have not used
it.

The ITE RAID controller is installed and configured properly in Device
Manager but if I try to open the RAID manager, I get a stop screen and
reboot. Could this be because there is only one drive attached?

My only complaint with this board so far is that due to a capacitor placed
too close to the ZIF socket, I could not use the heatsink I wanted. The
CPU
temp never goes over 51C so it is not a problem.