Upgrading from Ti4600 to FX5900Ultra
Andrew.
The unified driver should work. Power off, install the new card. The driver might default to somthing like 800x600 256 colour on first re-boot. If so, just power cycle your machine again and it should come up ok. Graeme. "Andrew Stirling" wrote in message ... About to install an FX5900 Ultra tomorrow. Just wondered if I need to uninstall my current drivers and then reinstall them after installing the card....or does the unified driver structure mean that this is unnecessary? -- Andrew |
"Andrew Stirling" wrote in message ... About to install an FX5900 Ultra tomorrow. Just wondered if I need to uninstall my current drivers and then reinstall them after installing the card....or does the unified driver structure mean that this is unnecessary? I swap back and forth between two nVidia cards. I had to install the same driver for both, but once I had done that, I can swap them and the registry has the info for both. If I power down and switch cards everything is setup when I restart. Too_Much_Coffee ® -- Andrew |
"Andrew Stirling" ha scritto nel messaggio ... Thanks everyone...I'm using 45.32 at the moment so I'll just give it a go and see what happens. 45.32?? :) |
"J.J. R." wrote in message
... "Andrew Stirling" ha scritto nel messaggio ... Thanks everyone...I'm using 45.32 at the moment so I'll just give it a go and see what happens. 45.32?? :) Oh Shut up!! It worked like a dream btw. First time I booted up my card was detected as a 5900Ultra but there were no nvidia properties in the display properties box. Just rebooted and it was fine. |
All times are GMT +1. The time now is 10:33 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
HardwareBanter.com