P4P800E Deluxe and Gainward GeForce 6800LE problem
 

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE card on my
ASUS P4P800E Deluxe based PC and encountered a very annoying problem. The
card has an alarm buzzer for the card's additional power supply which goes
off as soon as I turn on the switch on the power supply unit and keeps
buzzing until pressing the ATX power switch to start the PC. While the PC is
running there are no problems and the VGA card works great. If I shut down
the PC the alarm goes off again and buzzes until I turn off the switch on
the PSU.
If I install the VGA card in my other PC with ASUS CUSL2 motherboard, there
are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is there a
jumper setting to be changed on the motherboard or a BIOS setting that will
cure this?
All ideas are appreciated, thanks in advance

Mladen

"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE card
on my ASUS P4P800E Deluxe based PC and encountered a very annoying
problem. The card has an alarm buzzer for the card's additional power
supply which goes off as soon as I turn on the switch on the power
supply unit and keeps buzzing until pressing the ATX power switch to
start the PC. While the PC is running there are no problems and the
VGA card works great. If I shut down the PC the alarm goes off again
and buzzes until I turn off the switch on the PSU.
If I install the VGA card in my other PC with ASUS CUSL2 motherboard,
there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is there
a jumper setting to be changed on the motherboard or a BIOS setting
that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when the
system is in "Shut Down" state. You may want to take a close look at your
ATX power supply.

"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE card
on my ASUS P4P800E Deluxe based PC and encountered a very annoying
problem. The card has an alarm buzzer for the card's additional power
supply which goes off as soon as I turn on the switch on the power
supply unit and keeps buzzing until pressing the ATX power switch to
start the PC. While the PC is running there are no problems and the
VGA card works great. If I shut down the PC the alarm goes off again
and buzzes until I turn off the switch on the PSU.
If I install the VGA card in my other PC with ASUS CUSL2 motherboard,
there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is there
a jumper setting to be changed on the motherboard or a BIOS setting
that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when the
system is in "Shut Down" state. You may want to take a close look at your
ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same problem

"massa" wrote in message
...

"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE card
on my ASUS P4P800E Deluxe based PC and encountered a very annoying
problem. The card has an alarm buzzer for the card's additional power
supply which goes off as soon as I turn on the switch on the power
supply unit and keeps buzzing until pressing the ATX power switch to
start the PC. While the PC is running there are no problems and the
VGA card works great. If I shut down the PC the alarm goes off again
and buzzes until I turn off the switch on the PSU.
If I install the VGA card in my other PC with ASUS CUSL2 motherboard,
there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is there
a jumper setting to be changed on the motherboard or a BIOS setting
that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when the
system is in "Shut Down" state. You may want to take a close look at your
ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same problem

Is there a 4-pin Molex connector on the 6800LE? If so, do you have a
connector connected to it, one from a separate unused group of power
connectors?

"massa" wrote in
:


"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE
card on my ASUS P4P800E Deluxe based PC and encountered a very
annoying problem. The card has an alarm buzzer for the card's
additional power supply which goes off as soon as I turn on the
switch on the power supply unit and keeps buzzing until pressing the
ATX power switch to start the PC. While the PC is running there are
no problems and the VGA card works great. If I shut down the PC the
alarm goes off again and buzzes until I turn off the switch on the
PSU. If I install the VGA card in my other PC with ASUS CUSL2
motherboard, there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is
there a jumper setting to be changed on the motherboard or a BIOS
setting that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when
the system is in "Shut Down" state. You may want to take a close look
at your ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same
problem

Well, you definitely took a look at it! Surely you have checked for
jumpers on the card and possible driver settings that would cause this so
I will yield further comments to those who have experience with this
card.

"RaceFace" wrote in message
...

"massa" wrote in message
...

"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE card
on my ASUS P4P800E Deluxe based PC and encountered a very annoying
problem. The card has an alarm buzzer for the card's additional power
supply which goes off as soon as I turn on the switch on the power
supply unit and keeps buzzing until pressing the ATX power switch to
start the PC. While the PC is running there are no problems and the
VGA card works great. If I shut down the PC the alarm goes off again
and buzzes until I turn off the switch on the PSU.
If I install the VGA card in my other PC with ASUS CUSL2 motherboard,
there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is there
a jumper setting to be changed on the motherboard or a BIOS setting
that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when the
system is in "Shut Down" state. You may want to take a close look at
your
ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same
problem

Is there a 4-pin Molex connector on the 6800LE? If so, do you have a
connector connected to it, one from a separate unused group of power
connectors?


Yes, there is a 4-pin Molex connector on the card and a power connector is
plugged in it.

"Thagor" wrote in message
.. .
"massa" wrote in
:


"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE
card on my ASUS P4P800E Deluxe based PC and encountered a very
annoying problem. The card has an alarm buzzer for the card's
additional power supply which goes off as soon as I turn on the
switch on the power supply unit and keeps buzzing until pressing the
ATX power switch to start the PC. While the PC is running there are
no problems and the VGA card works great. If I shut down the PC the
alarm goes off again and buzzes until I turn off the switch on the
PSU. If I install the VGA card in my other PC with ASUS CUSL2
motherboard, there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is
there a jumper setting to be changed on the motherboard or a BIOS
setting that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when
the system is in "Shut Down" state. You may want to take a close look
at your ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same
problem

Well, you definitely took a look at it! Surely you have checked for
jumpers on the card and possible driver settings that would cause this so
I will yield further comments to those who have experience with this
card.

There are no jumpers on the card and the drivers are not loaded until the PC
is started, so it has to be a motherboard issue.
Thank you for your time

Is there anything else connected using the same molex connection as the
video? Mine couldn't share a power connection with my CD/DVD drive.
"massa" wrote in message
...

"RaceFace" wrote in message
...

"massa" wrote in message
...

"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE card
on my ASUS P4P800E Deluxe based PC and encountered a very annoying
problem. The card has an alarm buzzer for the card's additional power
supply which goes off as soon as I turn on the switch on the power
supply unit and keeps buzzing until pressing the ATX power switch to
start the PC. While the PC is running there are no problems and the
VGA card works great. If I shut down the PC the alarm goes off again
and buzzes until I turn off the switch on the PSU.
If I install the VGA card in my other PC with ASUS CUSL2 motherboard,
there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is
there
a jumper setting to be changed on the motherboard or a BIOS setting
that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when
the
system is in "Shut Down" state. You may want to take a close look at
your
ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same
problem

Is there a 4-pin Molex connector on the 6800LE? If so, do you have a
connector connected to it, one from a separate unused group of power
connectors?


Yes, there is a 4-pin Molex connector on the card and a power connector is
plugged in it.

"massa" wrote in message
...

"Thagor" wrote in message
.. .
"massa" wrote in
:


"Thagor" wrote in message
.. .
"massa" wrote in
:

Hi!
I have just installed a new Gainward Ultra/2100LE GeForce 6800LE
card on my ASUS P4P800E Deluxe based PC and encountered a very
annoying problem. The card has an alarm buzzer for the card's
additional power supply which goes off as soon as I turn on the
switch on the power supply unit and keeps buzzing until pressing the
ATX power switch to start the PC. While the PC is running there are
no problems and the VGA card works great. If I shut down the PC the
alarm goes off again and buzzes until I turn off the switch on the
PSU. If I install the VGA card in my other PC with ASUS CUSL2
motherboard, there are no alarms when the PC is turned off.
Has anyone had a similar problem and found a solution for it? Is
there a jumper setting to be changed on the motherboard or a BIOS
setting that will cure this?
All ideas are appreciated, thanks in advance

Mladen

Not sure what the buzzer is for but I would think it is a warning of
sorts. In this case, it would indicate a voltage supply problem when
the system is in "Shut Down" state. You may want to take a close look
at your ATX power supply.



I replaced the PSU with a new 480W Thermaltake, but still the same
problem

Well, you definitely took a look at it! Surely you have checked for
jumpers on the card and possible driver settings that would cause this so
I will yield further comments to those who have experience with this
card.

There are no jumpers on the card and the drivers are not loaded until the
PC is started, so it has to be a motherboard issue.
Thank you for your time


Problem solved! I removed the Modem from PCI slot 3 and everything works
normally!

"massa" wrote in
:

There are no jumpers on the card and the drivers are not loaded until
the PC is started, so it has to be a motherboard issue.
Thank you for your time


Problem solved! I removed the Modem from PCI slot 3 and everything
works normally!

Right! That would have been my next move too. :)