P4C800-E Deluxe single sata drive setup.
Hello
I just built a system with the P4C800-E motherboard. I have a single sata drive hooked up the SATA1 on the mother board, and have under Ide configuration (enhanced mode) (s-ata) if I use (p-ata) i get mode 6 dma instead of 5 What setting do I use. I'v tried to benchmark my hd with HD Tune and am getting 54 meg transfer rate, and if I try Sandra pro it will not benchmark my c partition (which Xp is on, is says my disk is to fragmented) If I run it on my E partition it gives me 37 meg transfer. Any help would be greatly appreciated Thank you Dave |
All times are GMT +1. The time now is 04:39 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
HardwareBanter.com