GA-7n400 Pro Video Post Issue
Components:
GA-7n400 Pro, 1600 Athon AMD(1400mhz), 2x256 3200 Geforce2Mx400 I can get the cpu fans spinning, the board is showing a orange light near the agp slot, I read in the manual that the motherboard doesnt support 3v 2XAgp cards, does this apply to my card? I have tried using my voodoo3 pci card but it will also not boot, I have set the CLK_RATIO to AUTO and CLK_SW to On, any suggestions would be greatly apreciated, thank you. ============== Posted through www.HowToFixComputers.com/bb - free access to hardware troubleshooting newsgroups. |
Sto wrote:
Components: GA-7n400 Pro, 1600 Athon AMD(1400mhz), 2x256 3200 Geforce2Mx400 I can get the cpu fans spinning, the board is showing a orange light near the agp slot, I read in the manual that the motherboard doesnt support 3v 2XAgp cards, does this apply to my card? I have tried using my voodoo3 pci card but it will also not boot, I have set the CLK_RATIO to AUTO and CLK_SW to On, any suggestions would be greatly apreciated, thank you. ============== Posted through www.HowToFixComputers.com/bb - free access to hardware troubleshooting newsgroups. Did you plug in the 12v additional power plug into the board? - I forgot that when I did mine and it has the same effect. Two power feeds go into it. |
Awesome it worked! But I can't get it to run without having the CLK_SW
on the off position thus setting the fsb to 100mhz (therfore the speed is at 1100mhz). When the CLK_SW is set to On and I configure the fsb speed it won't post video... atleast I have it running ============== Posted through www.HowToFixComputers.com/bb - free access to hardware troubleshooting newsgroups. |
only 4x and 8x supported as on the first page of the manual
K.K. "Sto" wrote in message ... Components: GA-7n400 Pro, 1600 Athon AMD(1400mhz), 2x256 3200 Geforce2Mx400 I can get the cpu fans spinning, the board is showing a orange light near the agp slot, I read in the manual that the motherboard doesnt support 3v 2XAgp cards, does this apply to my card? I have tried using my voodoo3 pci card but it will also not boot, I have set the CLK_RATIO to AUTO and CLK_SW to On, any suggestions would be greatly apreciated, thank you. ============== Posted through www.HowToFixComputers.com/bb - free access to hardware troubleshooting newsgroups. |
All times are GMT +1. The time now is 09:05 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
HardwareBanter.com