A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Gigabyte Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
all or part visible 4GB on GA-8ICXT by [email protected]
Hi, I am planning to get the Gigabyte server motherboard GA-8ICXT http://www.giga-byte.com/Server/Products/Products_ServerBoard_GA-8ICXT.htm it is based on Intel E7221 Chipset does anyone know if all of the installed 4GB memory will be visible to the OS? I saw this article on Intel's site about...
December 16th 05 05:34 AM
by [email protected] Go to last post
0 399
Lots of questions!! by JoSoap
There are lots of questions but very few answers, Could be not the right questions are being asked, or there are no Guru's to answer the questions. Jo
December 15th 05 10:37 PM
by JoSoap Go to last post
0 329
K8T800 pro by JoSoap
Are there any known problems with this board??? Josoap
December 15th 05 10:30 PM
by JoSoap Go to last post
2 233
Bad Caps by Davy
I really don't know where to post this, because you will see it applies to all mobos that use Taiwan caps, capacitors for short. I have a Gigabyte GA-7VAXP Rev. 1 mobo, I usually do an inspection and a 'dust down' at various intervals, this time I noticed one cap has a swollen top, these are the...
December 15th 05 08:02 PM
by RichH Go to last post
4 564
sata hard drives not being seen by [email protected]
I have four hard drives installed and my system (bios AND my computer) only sees the one in the "0" slot. Please help. I have the bios setting set to "enhanced. Thanks
December 15th 05 11:23 AM
by [email protected] Go to last post
0 324
GA-7VT880L mobo (KT880 chipset) and SATA drives by Clive Backham
I have a GA-7VT880L motherboard, which uses the VIA K880 chipset and the VT8237 southbridge controller. I recently bought a pair of Maxtor DiamondMax10 300GB SATA150 drives (type 6L300S0) to add as secondary storage (keeping the existing IBM Deskstar PATA drive as the boot device). The problem I'm...
December 14th 05 10:28 AM
by Clive Backham Go to last post
0 535
GA-8I945PMF, Half-Life 2, and Realtek HD audio by /mel/
It appears that if you're trying to use 5.1 audio in Half-life 2 on a board with a Realtek HD audio codec, eg the ALC882, it just aint going to work properly. There are driver issues, and they aren't yet fixed despite them being known about for some time. Bah bloody humbug. I've tried the...
December 13th 05 07:51 PM
by /mel/ Go to last post
0 446
Quad SLI Royal.....shipping news and price? by poker tommy
Does anyone know when the Quad SLI might ship and any idea of price yet? Tnks PT
December 13th 05 09:39 AM
by poker tommy Go to last post
0 375
Strange phenomenon by AnotherAnonymous
I turned my computer on today after it had been off for 2 days (it usually runs 24/7 so I thot I'd give it a break) and when I did the strangest thing happened. It turned itself on and off rapidly on off on off on off like a light bulb. I had to kill the power from the rear switch to stop it....
December 13th 05 02:46 AM
by AnotherAnonymous Go to last post
0 300
GA-6BXC AGP Speed? by LWeaver
I have a GA-6BXC Version 2.0 board and want to get a AGP video card for it but can not find out what the board will handle. Is the AGP slot on this motherboard 1X, 2X etc. Also are the newer video cards backward compatible to the older AGP speeds. Could someone please help me out with this...
December 11th 05 04:59 PM
by JK Go to last post
1 269
Zalman CNPS9500-LED on GA-8PENXP by Mark Lepak
Good Morning, I would like to know if it is possible to fit a Zalman CNPS9500-LED on to a GA-8PENXP motherboard to cool a P4 3.4Ghz CPU. Board mounted in a Lan-Li PC V1000 tower. Thanks -- Mark
December 11th 05 09:06 AM
by Mark Lepak Go to last post
0 190
8KNS high CPU temperatures by John McDonnell
I have a 8KNS and have no overclocking. It is a lightweight system with an old TNT32 Ultra AGP card. The ram is Crucual PC 3200 ECC running at DDR 400 dual channel. The temperatures are stable (38 to 42 C) until I do anything graphical. Then the temperature will go slowly up to the limit, which...
December 11th 05 07:31 AM
by McGrandpa Go to last post
8 375
CPU Purchase questions... by Jason Ash
I currently have a K8N Ultra-9 motherboard. I'm expecting to get my X- mas bonus from work in a couple weeks, and am looking at possibly upgrading my CPU. My question is, working with a $300-350 price limit, which would give more "bang for the buck?" I'm looking at either a 4000+ (San...
December 11th 05 05:45 AM
by jpsga Go to last post
1 358
wont boot with ide drive connected by teleman
Hi All have a gigabyte GA-7N400 Pro2 motherboard am using a sata drive with windows xp when I try to connect a IDE drive it allways trys to boot from this drive. Have set IDE drive as master and as slave have also updated to latest bios but still have problem.
December 10th 05 05:58 PM
by Travis Jordan Go to last post
2 364
Curious beeps from GA-8KNXP by Bradley Walker
Just last night I started noticed very low tone, soft but brief beeps coming from the speaker inside my PC case. Mind you, this is not coming from my PC speakers, but that single magnetic speaker attached to the case. Anyway every few minutes I get a very soft and low toned *beep-beep* that...
December 8th 05 10:42 PM
by Bioboffin Go to last post
1 262
GA 8N SLI shows Intel D830 as 1 processor only instead?? by LouieXII
In several reviews I see articles and reviews showing CPUZ as a 2 processor for the Intel 820, 830, 840 but when using CPUZ it is only 1. How do I enable it on BIOS to enable the Virtual Dual Core?
December 8th 05 05:16 AM
by LouieXII Go to last post
1 340
Overclocking in F6 BIOS for GA-K8N Pro by Chris
I have found that some people have had success using third party programs, mainly ClockGen, to overclock their GA-K8N Pro SLI. In ClockGen, for me, I went into the BIOS first and set the CPU down to x6 and the memory down to 100 speed. Boot into Windows and run Clockgen and it freezes if I try to...
December 6th 05 12:25 PM
by Chris Go to last post
0 234
Anyone ever had this problem when after installing an OS XP Win2k by LouieXII
It just keeps on restarting and going back to setup the entire OS all over again in spite of having it successfully installed on a fresh PC with all new components .... it just keep on installing.. when I remove the Win2k or XP CD, it says as Invalid Boot Drive, Drive System error, etc.....
December 6th 05 12:07 AM
by Vince Morgan Go to last post
8 449
8N SLI Royal Setttings quick questions for Intel D830/840 by LouieXII
In the settings for the Intel D830 Dual Core settings. 1. CPU Hyterthreading - set to enable or disabled 2. Limit CPUID Max to 3 3. No Execute Memory Protect Thanks
December 5th 05 10:15 PM
by LouieXII Go to last post
0 357
Please help - GA-K8NXP-SLI BIOS update problems by BillL
Hello all, My PC has been running quite happily on the F9 BIOS then I stupidly tried to change a setting (enable 1T timing) in the BIOS screen. I hit F10 and the PC wouldn't boot (series of long bleeps). I switched off the PC and restarted with the delete key. Anyhow the PC started (one long beep...
December 5th 05 09:23 PM
by BillL Go to last post
3 320
Post New Thread


Display Options
Showing threads 961 to 980 of 3996
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 01:31 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.